Flexi Pad Control Block - Sony XVS Series User Manual

a Independent key transition display section
b KEY ON buttons

Flexi Pad Control Block

You use the Flexi Pad control block for recalling and
saving snapshots, wipe snapshots, DME wipe snapshots,
and key snapshots, for recalling and creating macros, for
recalling and executing shotboxes and master timelines,
for entering the transition rate, and for other tasks.
a Independent key transition display section
The following information is displayed for the assigned
key on the [KEY ON] buttons.
b KEY ON
buttons • Key material name (key source name when a key source
is selected on the key bus of the cross-point control
block)
• DME channel or resizer being used
• Transition rate
b KEY ON buttons
Inserts or removes the key assigned to the button
instantaneously.
If a key is currently inserted, the corresponding key button
is lit.
You can assign a key (KEY1 to KEY8) of any switcher
bank (M/E-1 to M/E-5, PGM/PST) to the [KEY ON]
buttons in the Setup menu.
For details, see "Setting Independent Key Transition
Control Block Button Assignments" (page 376).
c AUTO
TRANS
c AUTO TRANS (auto transition) buttons
buttons
Inserts or removes the key assigned to the [KEY ON]
button with the set transition rate and transition type
automatically.
During the execution of the transition, the button is lit.
a Mode selection buttons
31
c UNDO button/
DEL button
d Bank selection
buttons
b Memory recall section