Cross-Point Control Block - Sony XVS Series User Manual

4M/E configuration example using 36-button modules for cross-point control block and AUX bus
control block
M/E-2 bank
M/E-1 bank
Cross-point control block (page 21)
PGM/PST (program/preset) bank
M/E-3 bank
M/E configuration example using transition control block (simple type)

Cross-Point Control Block

The cross-point control block is used to select the signals
to be used in the M/E banks and PGM/PST bank.
Note
To use as a cross-point control block, the control panel
target row must be set to an M/E row or P/P row in the
Engineering Setup >Panel >Config menu (7321).
For details, see "Setting the Configuration for Each
Bank" (page 372).
AUX bus control block
(page 43)
Transition control block (simple type) (page 29)
Menu panel (page 47)
Flexi Pad control block (page 31)
Transition control block (page 26)
Independent key transition control block (page 30)
21
Key control block (page 33)
Device control block
(page 37)
Utility/shotbox control
block (page 42)
Numeric keypad control block (page 40)
Key fader control block
(page 36)