Tally Copy Settings
You can copy the tally information for a particular source
to a different source.
The settings used are common to both parallel and serial
tallies.
Configuring Tally Copy
1
In the Engineering Setup >Router/Tally >Tally Copy
menu (7365), press [New].
The New menu (7365.1) appears.
2
Set the source to copy.
When setting more than one tally copy, you can
specify the copy-from source start and end addresses.
No.
Parameter Adjustment
1
Copy From
Copy-from source start address
(From)
2
Copy From
Copy-from source end address
(To)
3
Set the source on the copy destination.
No.
Parameter Adjustment
3
Copy To
Copy-to source start address
(From)
4
Copy To
Copy-to source end address
(To)
4
Press [Execute].
Modifying Tally Copy
1
In the Engineering Setup >Router/Tally >Tally Copy
menu (7365), press [Modify].
The Modify menu (7365.2) appears.
2
Select the copy-from and copy-to sources.
No.
Parameter Adjustment
1
Copy From Copy-from source
2
Copy To
Copy-to source
3
Press [Execute].
Deleting Tally Copy
1
In the Engineering Setup >Router/Tally >Tally Copy
menu (7365), select the tally copy.
2
Press [Delete].
431