Metal Settings; Dim And Fade Settings - Sony XVS Series User Manual

No. Parameter Adjustment
2 V Simultaneously adjust the top and
bottom resolution
3 All Simultaneously adjust the
resolution of all four sides
5 Coring Minimum value of edge to
emphasize
a) 0.00 is the original input image, and 100.00 gives an image
transformed by the Sketch effect.
b) The larger the Clip value, the narrower the outline width.
5
If a setting other than [Sharp] is selected in step 3, use
the following procedure as required.
To adjust the outline color for [Edge Color] or
[Draw]
Press [Edge Matte], and set the following parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
To apply color to sections other than the [Draw]
outlines
Press [Matte], and set the following parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
To select the signal to mix with for [Relief]
In the <Chroma Type> group, select the signal to mix
with the relief pattern.
Matte: Select a single color matte. You can adjust the
following parameters.
No. Parameter Adjustment
2 Saturation Saturation
3 Hue Hue
Video: Select the input video signal.
6
To invert white and black in the extracted video, or to
invert the outlines and the sections other than the
outlines, press [Nega], turning it on.
To mask the Sketch effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 224).

Metal Settings

Applying the Metal effect
1
Open the DME >Enhanced Video Modify >Metal
menu (4172).
2
Press [Metal], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Mix Ratio
2 Y Clip
3 Y Gain
4 Y Offset
4
In the <Metal Mode> group, select the type of metallic
gloss.
Gold: Give a gold gloss to the input video.
Silver: Give a silver gloss to the input video.
Rainbow: Give a rainbow color gloss to the input
video.
Variable: Give a metallic gloss to the input video in
any color. You can set the following parameters.
No. Parameter Adjustment
2 Saturation
3 Hue
To mask the Metal effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 224).

Dim and Fade Settings

Applying the Dim effect
1
Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2
Press [Dim], turning it on.
3
Set the following parameters.
223
Mix level for Metal effect video and
input video
Clip level of input signal luminance
level
Gain level for clip-adjusted input
signal luminance level
Offset added to clip and gain-
adjusted input luminance signal
Saturation
Hue