Table of Contents
Advertisement
3
Press and hold the [PRE MACRO] button or [POST
1)
MACRO] button
in the cross-point pad, and press the
[PRIOR SET] button or [LIMIT SET] button in the
control block containing the fader lever operated in
step 2.
1) Only when setting a macro attachment to the start point or end point
of fader lever operation, the use of the [PRE MACRO] and [POST
MACRO] buttons is different.
• To set the operation start point (0%): Press and hold the [PRE
MACRO] button.
• To set the operation end point (100%): Press and hold the [POST
MACRO] button.
This assigns the register recalled in step 1 to the fader
lever position selected in step 2.
To check macro attachment settings
Press and hold the [PRE MACRO] button or [POST
MACRO] button. While the button is pressed, the fader
lever position where the macro attachment is set appears in
the following places.
Transition indicator in the transition execution section:
The indicator lights at the position where the macro
attachment is set.
Transition rate indication in the transition execution
section: This shows the fader lever position where the
macro attachment is set, as a percentage value (fader
lever start position as 0%, end position 100%).
Removing macro attachment settings
To cancel a macro attachment to a button
Press and hold the [PRE MACRO] or [POST MACRO]
button in the cross-point pad and press the blinking 3rd
row cross-point button. The macro attachment setting is
canceled.
To cancel a macro attachment to a fader lever
Press and hold the [PRE MACRO] button or [POST
MACRO] button in the cross-point pad, and press the
[PRIOR SET] button or [LIMIT SET] button in the control
block containing the fader lever with the macro
attachment.
To delete individual macro attachment settings
You can delete individual settings of a macro attachment
assigned to a button.
1
Open the Macro >Attachment menu (5421).
2
Select the macro attachment setting you want to delete.
3
Press [Delete].
4
Check the message, then press [Yes].
To delete all macro attachment settings in a
single operation
1
Open the Macro >Attachment menu (5421).
2
Press [All Clear].
3
Check the message, then press [Yes].
Switching macro attachment assignment
mode (button number mode and pair
number mode)
When assigning a macro attachment to a cross-point
button, you can select button number mode or pair number
(video and key) mode.
Note
If you change the mode using the following procedure, all
macro attachment data relating to cross-point buttons is
lost.
1
Open the Macro >Attachment menu (5421).
2
In the <Xpt Attachment Mode> group, select one of
the following.
Button Mode: Button number mode. Assign an
attachment for combination of bus and button
numbers.
Pair Mode: Pair number mode. Assign an attachment
for combination of bus and pair numbers.
3
Check the message, then press [Yes].
Notes
• In pair number mode, carry out operations as follows.
- When a single pair number is assigned to multiple
cross-point buttons, pressing any of them executes the
macros of all cross-point buttons to which the same
pair number is assigned. Further, if you delete any of
these assignments, this deletes all assignments to the
same pair number.
- If you assign a pair number to a different cross-point
button, the attachment settings are also transferred to
the new cross-point button.
• When macro attachment data is loaded and overwrites
existing data, this also changes the button number mode
or pair number mode setting.
Displaying the Macro Attachment
Settings
In the Macro >Attachment menu (5421), you can display
the macro attachment list to check the macro attachment
settings.
The following items are displayed in the list.
• Block: Panel block names.
• Button: Names of buttons with macro attachments (up
to 30 characters).
345
Advertisement
Table of Contents
