Table of Contents
Advertisement
When the Keyframe Strobe effect is set, the effects are
equivalent to operation using keyframes. In this case as
well, cancel the unnecessary DME settings.
Executing an independent key transition
(key fader control block)
Independent key transition type selection buttons
Key delegation buttons
Fader lever
Key fader control block
1
Select the target key to operate using the key
delegation buttons.
2
Set the transition type using the independent key
transition type selection buttons.
Press the [MIX], [WIPE], [DME WIPE], or [CUT]
button, turning it on.
When [Independ] is selected in the <Key Transition>
group of the Engineering Setup >Switcher >Transition
menu (7334), you can set the transition type used when
inserting and removing a key.
If the transition type used when inserting a key is
displayed, you can select the transition type used when
removing a key by pressing and holding the [SHIFT]
button and pressing an independent key transition type
selection button. If the transition type used when
removing a key is displayed, you can select the
transition type used when inserting a key using the
same operation.
3
Set the independent key transition rate.
The independent key transition rate is set using the
menu (see page 97), or utility/shotbox control block
and numeric keypad control block (see page 97).
4
Execute the independent key transition.
KEY ON buttons
AUTO TRANS buttons
To insert or remove the key gradually with a mix or
wipe, press the [AUTO TRANS] button for the
corresponding key or operate the fader lever. Pressing
the [AUTO TRANS] button executes the transition at
the preset transition rate.
To insert/remove the key instantaneously, press the
[KEY ON] button for the corresponding key.
Note
You can also set the key delegation button for
operation by the fader lever and the "play" (range of
movement that does not start operation) at both ends of
the fader lever.
For details, see "Setting the Buttons and Fader Levers
on the Key Fader Control Block" (page 374).
Selecting Independent Key
Transition Type
There are two ways of setting the transition type: using the
Flexi Pad control block or using the Transition/Video
Process menu for the target key on the M/E or PGM/PST
bank.
You can also set the transition type using independent key
transition operations on the key fader control block (see
page 96).
When the independent key transition mode is set to
[Independ] in the <Key Transition> group of the
Engineering Setup >Switcher >Transition menu (7334),
you can select the transition type used when inserting and
removing a key.
Setting the independent key transition
type (Flexi Pad control block)
If the independent key transition mode is set to [Independ],
setting the transition type while a key is not inserted will
set the transition type for key insertion, and setting the
transition type while a key is inserted will set the transition
type for key removal.
1
In the Flexi Pad control block of the target switcher
bank, press the [KEY] button.
This switches the memory recall section to
independent key mode.
2
Select the target key.
Press one of the [KEY1] to [KEY8] buttons, turning it
on.
3
Set the transition type.
96
Advertisement
Table of Contents
