Table of Contents
Advertisement
16:9: Set the screen aspect ratio to 16:9.
4:3: Set the screen aspect ratio to 4:3.
3
Press [Aspect Execute].
4
Check the message, then press [Yes].
Power-On (Startup) State
Selection
This sets the initial state of each device when the system is
powered on.
Select Resume mode or Custom mode for each device.
Resume mode
This resumes operation with the state in force when the
power was last turned off. This setting is only available for
the switcher and control panel.
Custom mode
This mode uses settings saved in non-volatile memory
within each device.
You can set Setup mode and Initial Status mode settings
separately.
• Setup mode: Set one of the following setup states to use
after powering on.
User: Start up using the user data previously saved with
[Setup Define].
Factory: Start up with the factory default settings.
• Initial Status mode: Set one of the following states of
each device after powering on (excludes Setup mode
settings).
User: Start up using the user data previously saved with
[Initial Status Define].
Factory: Start up with the factory default settings.
For details, see "Saving and Recalling Setup Data"
(page 367).
366
Advertisement
Table of Contents
