Saving A Macro; Deleting A Macro - Sony XVS Series User Manual

For details about bank selection, see "Bank and
register selection in the Flexi Pad control block"
(page 312).
3
While pressing the [MCRO] button, press the button
for the target register for operation.
This switches the Flexi Pad control block to macro
editing mode, and the [MCRO] button changes color
to red.
The selected bank and register number are displayed
on the top right button in the memory recall section,
and the number of the current event and total number
of events are displayed on the center button in the
bottom row.
4
Specify an edit point.
• To move the edit point to the event immediately
following the current event, press the [>> NEXT]
button.
• To move the edit point to the event immediately
preceding the current event, press the [<< PREV]
button.
Inserting an event
1
Specify an edit point (see page 335).
2
If required, press the [AUTO INS] button to toggle the
auto insert mode.
3
Create an event.
When auto insert mode is enabled, the event is
registered after the current event automatically.
When auto insert mode is disabled, press the [INS]
button to register the event after the current event.
4
Repeat steps 2 and 3 to insert the required events in the
macro.
Modifying an event
1
Specify an edit point (see page 335).
2
When the [AUTO INS] button is lit orange, press the
button to disable auto insert mode.
3
Create an event.
4
Press the [MOD] button.
Deleting an event
1
Specify an edit point (see page 335).
2
Press the [DEL] button in the memory recall section.
Deleting all events
You can delete all events within the selected macro
register.
1
Specify an edit point (see page 335).
2
Press the [ALL] button, turning it on orange.
3
Press the [DEL] button in the memory recall section.
Inserting a pause event
1
Specify an edit point (see page 335).
2
If required, press the [AUTO INS] button to toggle the
auto insert mode.
3
Press the [PAUSE] button.
This switches the memory recall section to numeric
keypad mode.
4
Enter the pause duration (0, or 1 to 999 frames), and
press the [ENTER] button.
When auto insert mode is enabled, the pause event is
registered after the current event automatically.
When auto insert mode is disabled, press the [INS]
button to register the pause event after the current
event.

Saving a Macro

Press the [STORE XXX] button in the memory recall
section (where XXX is the number of the currently
selected register).
This saves the edited macro in the register.
To exit macro editing without saving, press the [EXIT]
button.

Deleting a Macro

1
In the Flexi Pad control block, press the [MCRO]
button.
This switches the memory recall section to macro
operation mode.
The last recalled bank is displayed.
2
Use the bank selection buttons to select the target bank
for operation.
Select from bank 0 to 25 (register number 1 to 250).
336