Table of Contents
Advertisement
Basic Independent Key
Transition DME Wipe
Setting Operations
You carry out independent key transition DME wipe
setting operations using the DME Wipe Adjust menu for
each keyer.
For details about independent key transitions, see
"Independent Key Transitions" (page 92).
This section describes operations of key 1 on the M/E-1
bank (M/E-1 >Key1 >Transition/Video Process >DME
Wipe Adjust menu) as an example.
Selecting an Independent Key
Transition Wipe Pattern
1
In the M/E-1 >Key1 >Transition/Video Process menu
(1117), press [DME Wipe Adjust].
The DME Wipe Adjust menu (1117.3) appears.
2
In the <Pattern Select> group, press [1ch] for 1-
channel mode or [2ch] for 2-channel mode.
The 1ch Pattern Select menu (1117.4) or 2ch Pattern
Select menu (1117.5) appears.
3
Press the button for the desired DME wipe pattern
group to select it.
The patterns from the selected pattern group appear on
the screen.
If executing a DME wipe using a resizer
Select [Resizer Slide], [Resizer Squeeze], or [Resizer
Frame I/O] in the DME wipe pattern group.
4
Press the desired pattern to select it.
Setting Independent Key Transition
DME Wipe Modifiers
You can add modifiers, such as pattern position and size,
to an independent key transition DME wipe.
For an overview of modifiers and supported pattern
numbers, see "DME Wipe Pattern Variation and
Modifiers" (page 147).
Specifying the DME wipe direction
(Direction)
In the <Direction> group of the M/E-1 >Key1 >Transition/
Video Process >DME Wipe Adjust menu (1117.3), select
one of the following.
Normal: Wipe in normal direction.
Normal/Reverse: Wipe in the normal and reverse
direction alternately for each transition.
Reverse: Wipe in the opposite direction to normal.
Modifying a DME wipe pattern edge (Edge)
1
In the <Edge> group of the M/E-1 >Key1 >Transition/
Video Process >DME Wipe Adjust menu (1117.3),
select one of the following.
Border: Border
Soft Border: Soft border
2
Set the following parameters.
When [Border] is selected
No.
Parameter Adjustment
1
Width
3
Luminance Luminance of border color
4
Saturation
5
Hue
When [Soft Border] is selected
No.
Parameter Adjustment
1
Width
2
Inner Soft
3
Luminance Luminance of border color
4
Saturation
5
Hue
Setting the DME wipe pattern position
(Positioner)
1
In the <Position> group of the M/E-1 >Key1
>Transition/Video Process >DME Wipe Adjust menu
(1117.3), press [Position], turning it on.
2
Set the following parameters.
No.
Parameter Adjustment
1
H
2
V
153
Border width
Saturation
Hue
Border width
Degree of softness inside the
border
Saturation
Hue
Horizontal position
Vertical position
Advertisement
Table of Contents
