Table of Contents
Advertisement
For details about selecting a register, see "Register
selection in the numeric keypad control block"
(page 285).
9
Press the [ENTER] button.
The created macro is saved in the register, and the
[STORE STATS] button and [RCALL] button are lit
amber.
The display shows the saved register number.
Note
While carrying out macro editing in the numeric keypad
control block and utility/shotbox control block, no macro
operation other than macro recalling is possible in other
control blocks.
To cancel the saving of a macro
While the [STORE STATS] button is lit amber, press and
hold the [STORE STATS] button and press the [UNDO]
button.
To merge a macro set in a macro attachment
While creating/editing a macro, if you press a button for
which a macro attachment is set, the macro in the register
assigned to the button is recalled, and the following occurs.
• When auto insert mode is enabled, it is merged with the
macro being edited. However, the macro assigned to the
button is not executed.
• When auto insert mode is disabled, it is stored in the
paste buffer. Pressing the [PASTE] button in the utility/
shotbox control block merges it with the macro being
edited.
Specifying an edit point
1
In the numeric keypad control block, press the
[MCRO] button.
The control block switches to macro operation mode,
and the [MCRO] button and [RCALL] button light
amber.
2
Recall the target register for operation (see page 329).
3
Holding down the [MCRO] button, press the [STORE]
button.
This switches the numeric keypad control block to
macro editing mode. The [STORE] button blinks red,
and the [MCRO] button changes color to red.
4
Press the [KF MCRO EDIT] button in the utility/
shotbox control block.
Selecting keyframe/macro editing mode in the utility/
shotbox control block when the numeric keypad
control block is in macro editing mode switches the
memory recall buttons to the assignments for macro
editing, and the [EDIT ENBL] button turns on red.
5
Specify an edit point using buttons in the utility/
shotbox control block.
• To move the edit point to the event immediately
following the current macro event, press the [NEXT
EVENT] button.
• To move the edit point to the event immediately
preceding the current macro event, press the [PREV
EVENT] button.
• To move the edit point by specifying an event
number, press the [GOTO EVENT] button, then
enter the event number using the numeric keypad
control block, and press the [ENTER] button.
Inserting an event
1
Specify an edit point (see page 331).
2
If required, set auto insert mode using the [AUTO
INS] button of the utility/shotbox control block.
3
Create an event.
When auto insert mode is enabled, the event is
registered automatically.
Auto insert mode is disabled, press the [INS] button in
the utility/shotbox control block to register events.
4
Repeat steps 2 and 3 to insert the required events in the
macro.
Modifying an event
1
Specify an edit point (see page 331).
2
When the [AUTO INS] button is lit orange in the
utility/shotbox control block, press the button to
disable auto insert mode.
3
Create an event.
4
Press the [MOD] button in the utility/shotbox control
block.
Deleting an event
1
Specify an edit point (see page 331).
2
Press the [DEL] button in the utility/shotbox control
block.
331
Advertisement
Table of Contents
