Table of Contents
Advertisement
Example 2: When the common transition [AUTO TRANS]
button is pressed later
Basic Independent Key Transition
Operations
Independent key transition operations are performed using
the transition control block, independent key transition
control block, or key fader control block.
Executing an independent key transition
(transition control block)
Independent key transition operations are performed using
the independent key transition execution section of the
transition control block. The same operations can also be
performed using the independent key transition control
block.
Note
Independent key transition operations are not supported
using the transition control block (simple type).
Independent key
transition (mix)
Transition (wipe)
1
The transition is
completed with the
key removed.
2
3
• In an independent key transition, the pattern limit
• When the following DME effects are set, the DME
95
Independent key transition display section
KEY1 ON to KEY4 ON buttons
Transition control block
Set the independent key transition type.
The independent key transition type is set using the
menu (see page 97) or Flexi Pad control block (see
page 96).
Set the independent key transition rate.
The independent key transition rate is set using the
menu (see page 97), or utility/shotbox control block
and numeric keypad control block (see page 97).
Execute the independent key transition on the
transition control block or independent key transition
control block.
To insert or remove the key gradually with a mix or
wipe, press the [AUTO TRANS] button. This executes
the transition at the preset transition type and transition
rate.
To insert/remove the key instantaneously, press the
[KEY1 ON] to [KEY8 ON] buttons (or the [KEY ON]
button for the corresponding key).
Notes
function is not available.
effects may be applied during wipe transitions. If the
effects are not necessary, cancel the DME settings.
- Trail
- Motion Decay
- Wind
KEY5 ON to KEY8 ON buttons
AUTO TRANS button
Advertisement
Table of Contents
