Table of Contents
Advertisement
6
In the <PNL Select> group, select the control panel
(PNL1, PNL2, PNL3) used for operation of the
connected device.
Clearing serial port settings
1
In the <DCU Select> group of the Engineering Setup
>DCU >Serial Port Assign menu (7355), select the
target to set (DCU1 or DCU2).
2
Select the serial port.
3
Press [Clear].
Configuring Detailed Settings for an
External Device Connected to the
Serial Port
After configuring the serial port, configure detailed
settings for operation of the connected external device.
Configuring detailed settings for a P-Bus
device
1
In the <DCU Select> group of the Engineering Setup
>DCU >Serial Port Assign menu (7355), select the
target to set (DCU1 or DCU2).
2
Select the serial port connected to the target P-Bus
device to set.
3
Press [Port Setting].
The P-Bus Setting menu (7355.1) appears.
The target serial port, slot number, device type, serial
port name, and PNL number appear at the top of the
status area. The device name and response speed
settings state for each command appears at the bottom
on the status area.
4
Select an ID for which to set a device name.
5
In the <Name> group, press [Set].
6
Enter a name using the keyboard window, and press
[Enter].
To return the device name to the default name
In the <Name> group, press [Clear].
7
Select the target command to set.
8
Set the response speed.
No.
Parameter Adjustment
3
Delay
9
Press [Delay Set].
10
Repeat steps 4 to 9 as required to set other commands.
Configuring detailed settings for a VTR
1
In the <DCU Select> group of the Engineering Setup
>DCU >Serial Port Assign menu (7355), select the
target to set (DCU1 or DCU2).
2
Select the serial port connected to the target VTR to
set.
3
Press [Port Setting].
The VTR Setting menu (7355.2) appears.
The target serial port, slot number, device type, serial
port name, PNL number, and timecode source appear
at the top of the status area. The VTR constants appear
at the bottom of the status area.
4
In the <TC Source> group, select the timecode source
(reference signal for determining the tape position).
LTC: Use LTC (Longitudinal Time Code). When
interpolation data is returned from a VTR, use that
interpolation data.
LTC:VITC: Normally use LTC, except when the tape
is moving at speeds at which LTC cannot be read,
use VITC (Vertical Interval Time Code). When
interpolation data is returned from a VTR, use that
interpolation data.
VITC: Use VITC (Vertical Interval Time Code).
CTL: Use CTL (Control) pulse or timer counter pulse.
Use this only for a tape on which no timecode is
recorded.
The displayed tape position is based on the reference
signal specified here.
5
Select the target item to set.
423
Response field (number of fields)
Advertisement
Table of Contents
