Table of Contents
Advertisement
Bottom Left: Bottom left corner
Bottom Right: Bottom right corner
All: All four corners
5
Set the position of the corner selected in step 4.
No.
Parameter Adjustment
1
Pos X
Movement in X-axis direction
2
Pos Y
Movement in Y-axis direction
Resetting the corner positions
Press [Reset Corner].
Selecting the target area of the foreground
When the foreground is cropped, select the target range.
In the Corner Pinning menu (4142), press [Crop Link],
turning it on, to set the cropped image as the target range.
When [Crop Link] is disabled, the whole picture, including
the invisible cropped portions (gray portions in the
following diagram), become the target range.
Target range with Crop Link enabled
Target range with Crop Link disabled
(
Adjusting the density of the foreground
You can adjust the density of the foreground image to be
translucent so that the background shows through, making
it easier to position the corners.
Note
This setting is not saved in a keyframe or snapshot.
1
In the DME >Non Linear/Corner Pin >Corner Pinning
menu (4142), press [Video Through], turning it on.
2
Set the following parameter.
indicates the target range)
254
No.
Parameter Adjustment
4
Density
Image density
Adjusting the zoom
You can enlarge the image around the corner being
adjusted, to allow fine positioning of the corner.
Notes
• This setting is not saved in a keyframe or snapshot.
• This function is only enabled when combine is set.
• When all four corners are being positioned, this function
cannot be used.
1
In the DME >Non Linear/Corner Pin >Corner Pinning
menu (4142), press [Zoom Enable], turning it on.
2
Set the following parameter.
No.
Parameter Adjustment
5
Zoom
Degree of zooming in on the
corners
Zoom disabled
Zoom enabled
Advertisement
Table of Contents
