Setting An Independent Key Transition Dme Wipe; Setting A Dme Wipe Pattern For An Independent Key Transition; Setting Independent Key Transition Dme Wipe Modifiers - Sony XVS-G1 User Manual

Setting an Independent
Key Transition DME Wipe
DME wipe patterns and modifiers for independent key
transitions are configured using the menu.
This section describes the M/E-1 key 1 menu as an
example.
Setting a DME Wipe Pattern for an
Independent Key Transition
Note
In an independent key transition, wipe pattern parameters
cannot be adjusted.
Selecting a DME wipe pattern
1
Open the DME wipe pattern selection menu.
In 1-channel mode, open the Home > M/E-1 > Key1
> Transition > 1ch Pattern menu (11101.54).
In 2-channel mode, open the Home > M/E-1 > Key1
> Transition > 2ch Pattern menu (11101.55).
2
Press the button for a DME wipe pattern group.
The patterns in the selected group are displayed.
For 1-channel mode
Select from the following DME wipe pattern groups.
Slide / Squeeze: Slide and squeeze
Split / Door: Split and door
Page Turn: Page turn
Roll: Roll
Frame I/O: Frame in/out
Resizer Slide / Squeeze: Resizer slide and squeeze
Resizer Frame I/O: Resizer frame in/out
For 2-channel mode
Select from the following DME wipe pattern groups.
Page Turn: Page turn
Roll: Roll
3
Set the button for the target wipe pattern to the on
state.
Setting Independent Key Transition
DME Wipe Modifiers
For details about the supported modifiers, see "Setting
Modifiers" (page 167).
Setting the DME wipe direction (Direction)
1
Open the Home > M/E-1 > Key1 > Transition > DME
Wipe menu (11101.53).
2
In the [Direction] group, select a DME wipe
direction.
Normal: DME wipe in normal direction.
Normal/Reverse: Alternate directions between
normal and reverse after each transition.
Reverse: DME wipe in the opposite direction of the
normal direction.
Modifying a DME wipe pattern edge
(Edge)
1
Open the Home > M/E-1 > Key1 > Transition > DME
Wipe menu (11101.53).
2
In the [Edge] group, select a type of edge.
Border: Adds a border to a pattern.
Soft Border: Softens a border applied to a pattern.
When the [Border] button is selected, set the
following parameters.
No. Parameter
1 Width
3 Luminance
4 Saturation
5 Hue
When the [Soft Border] button is selected, set the
following parameters.
No. Parameter
1 Width
2 Inner Soft
3 Luminance
4 Saturation
5 Hue
171
Adjustment
Border width
Luminance
Saturation
Hue
Adjustment
Border width
Softness of inner edge of
border
Luminance
Saturation
Hue