Required Components - Siemens SINAMICS G120 CU240B-2 Operating Instructions Manual

Connection to a fieldbus
6.3 Communication via PROFIBUS
What prior knowledge is required?
In this example, it is assumed that readers know now to basically use an S7 control and the
STEP 7 engineering tool and is not part of this description.
6.3.1.2

Required components

The examples given in this manual for configuring communication between the control and
inverter are based on the hardware listed below:
Table 6- 2
Component
Central controller
Power supply
S7 CPU
Memory card
DIN rail
PROFIBUS connector
PROFIBUS cable
Drive
SINAMICS G120 Control Unit
SINAMICS G120 Power Module
PROFIBUS connector
In order to configure communication you also require the following software packages:
Table 6- 3
Component
SIMATIC STEP 7
STARTER
Drive ES Basic
Drive ES Basic is the basic software of the engineering system, which combines the drive
technology and Siemens controllers. The STEP 7 Manager user interface acts as a basis
with which Drive ES Basic is used to integrate drives in the automation environment with
respect to communication, configuration, and data storage.
106
Hardware components (example)
Software components
Type
PS307 2 A
CPU 315-2DP
MMC 2MB
DIN rail
PROFIBUS connector
PROFIBUS cable
CU240E-2 DP
Any
PROFIBUS connector
Type (or higher)
V5.3 + SP3
V4.1 SP5
V5.4
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
Order no.
6ES7307-1BA00-0AA0
6ES7315-2AG10-0AB0
6ES7953-8LL11-0AA0
6ES7390-1AE80-0AA0
6ES7972-0BB50-0XA0
6XV1830-3BH10
6SL3244-0BB12-1PA0
-
6GK1500-0FC00
Order no.
6ES7810-4CC07-0YA5
6SL3072-0AA00-0AG0
6SW1700-5JA00-4AA0
Qty
1
1
1
1
1
1
1
1
1
Qty
1
1
1