Pre-assignment of the terminal strip for the CU240B-2 DP
Figure 4-4
Note
Assignment of the terminal strip after basic commissioning
The CU240B-2 DP Control Unit is assigned in the same way as the CU240B-2 (without
PROFIBUS interface) when you deselect bus communication for both the command sources
and the setpoint value specification during basic commissioning of the inverter.
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
CU240B-2 DP: Wiring example for the factory settings
4.3 Commissioning with factory settings
Commissioning
65