Siemens SINAMICS G120 CU240B-2 Operating Instructions Manual page 231

Figure 7-30
Use parameter P0170 to define the number of command data sets (2, 3 or 4).
Table 7- 42
Parameter
P0010 = 15
P0170
P0010 = 0
The command data sets are switched over using parameters P0810 and P0811. Parameters
P0810 and P0811 are interlinked to control commands, e.g. the digital inputs of the inverter,
using BICO technology.
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
CDS switchover in the inverter
Selecting the number of command data sets
Description
Drive commissioning: Data sets
Number of command data sets (factory setting: 2)
P0170 = 2, 3 or 4
Drive commissioning: Ready
7.11 Switchover between different settings
Functions
231