Siemens SINAMICS G120 CU240B-2 Operating Instructions Manual page 88

Commissioning
4.6 Back-up the settings and transfer
Backing up your settings
We recommend that you insert the card before switching on the inverter for the first time.
The inverter then automatically ensures that the actual parameter setting is saved both in the
inverter as well as on the card.
The following describes how you can save the inverter parameter setting on the memory
card subsequently.
Note
The data transfer can take several minutes.
If you wish to transfer the parameter setting from the inverter on to a memory card (Upload),
you have two options:
Automatic upload
 Switch off the inverter power supply (or disconnect the
 Insert an empty memory card into the inverter.
 Then switch the inverter power supply back on again
Afterwards, the inverter copies its parameter setting onto the memory card.
NOTICE
If the memory card is not empty and already contains a parameter setting, the inverter will
take on the parameter setting from the memory card. The previous setting in the inverter
will be deleted.
88
Control Unit from the Power Module).
(or reconnect the Control Unit to the Power Module).
Transfer the setting to the
empty memory card
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA