Pre-assignment of the terminal strip for the CU240E-2 DP and CU240E-2 DP-F
Figure 4-6
Note
Assignment of the terminal strip after basic commissioning
The CU240E-2 DP (F) Control Unit is assigned in the same way as the CU240E-2 (F)
(without PROFIBUS interface) when you deselect bus communication for both the command
sources and the setpoint value specification during basic commissioning of the inverter.
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
CU240E-2 DP and CU240E-2 DP-F: Wiring example for the factory settings
4.3 Commissioning with factory settings
Commissioning
67