Siemens SINAMICS G120 CU240B-2 Operating Instructions Manual page 61

Table 4- 1 Command and setpoint sources
Parameter
P0700 = 2 or 6
P1000 = 2 or 6
Table 4- 2 Factory settings of additional important parameters
Parameter Factory setting
P0010 0
P0100 0
P0300 1
P0304 400
P0305 depends on the
Power Module
P0307 depends on the
Power Module
P0308 0
P0310 50
P0311 1395
P0335 0
P0625 20
P0640 200
P0970 0
P1080 0
P1082 50
P1120 10
P1121 10
P1300 0
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
Description
Select the command source
2: Digital inputs (P0701 ... P0709) (factory setting for CUs without PROFIBUS interface)
6: Fieldbus (P2050 ... P2091), (factory setting for CUs with PROFIBUS DP interface)
Select the setpoint source
2: Analog setpoint (factory setting for CUs without PROFIBUS DP interface)
6: Fieldbus (factory setting for CUs with PROFIBUS DP interface)
Meaning of the factory
setting
Ready to be entered
Europe [50 Hz]
Induction motor
[V]
[A]
[kW/hp]
[cos phi]
[Hz]
[rpm]
Non-ventilated: Shaft-
mounted fan in the motor
[°C]
[A]
Locked
[rpm]
[rpm]
[s]
[s]
V/f control with linear
characteristic
4.3 Commissioning with factory settings
Name of the parameter and comments
Drive, commissioning parameter filter
IEC/NEMA motor standard
IEC, Europe

NEMA, North America

Note: This parameter cannot cannot be changed in FW4.3.
Motor type selection (induction motors / synchronous
motor)
Rated motor voltage (in accordance with the rating plate in
V)
Rated motor current (in accordance with the rating plate in
A)
Rated motor power (in accordance with the rating plate in
kW/hp)
Rated motor power factor (in accordance with the rating
plate in cos 'phi'). If P0100=1, 2, then P0308 has no
significance.
Rated motor frequency (in accordance with the rating plate
in Hz)
Rated motor speed (in accordance with the rating plate in
rpm)
Motor cooling type (specify the motor cooling system)
Motor ambient temperature
Current limit (of the motor)
Reset drive parameters (restore to the factory settings)
Minimum speed
Maximum speed
Ramp-function generator, ramp-up time
Ramp-function generator, ramp-down time
Open-loop/closed-loop control operating mode
Commissioning
61