2.10.3 Access Control Functions - Bosch D9412GV3 Program Entry Manual

D9412GV3/D7412GV3 | Program Entry Guide | 2.0
View Memory
Default: E
Selection:
-, E, or P
Function Function Name
No.
9 View Event
Memory
Use this function to view prior alarm, trouble, and
supervisory activity occurring since the last time the
system armed. Event memory is not cleared until the
area re-arms.
View Point Status
Default: E
Selection:
-, E, or P
Function Function Name
No.
10 View Point Status
Use this function to view points assigned to the area
where the keypad is assigned. This function shows
point text and the electrical condition (normal, open,
short, and missing) of each point in the area.
Walk Test
Default: E
Selection:
-, E, or P
Function Function Name
No.
11 Walk Test
Use this function to test Controlled points in areas
within the keypad's scope without sending reports to
the central station. 24-hour points cannot be tested
using this Walk Test Mode.
Fire Test
Default: P
Selection:
-, E, or P
Function Function Name
No.
12 Fire Test
Use this function to test 24-hour points in areas within
the scope of the keypad where the function is
entered. Controlled points, P## Type 1, 2, 3, cannot
be tested using the Fire Walk Test Mode.
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Panel and Area Wide Parameters
Send Report
Default:
Selection:
Alternate Function
Keystroke No.
[COMMAND][4][0] 13
Use this function to test the communication link
between the control panel and the central station
receiver(s). It can send a Test Report or a Status
Report to the phone numbers programmed in
Routing. The Test Report includes additional
information if Expand Test Report is enabled in
Section 2.1 Phone on page 12.

2.10.3 Access Control Functions

Door Control
Alternate
Keystroke
Default:
(Menu function
only)
Selection:
Function
No.
14
#14 Door Control [COMMAND][4][6])
This top level display must be enabled for the user to
access the cycle door, unlock door, and secure door
functions (refer to Section 2.10.6 Authority Level
Selections on page 66). Use this item when
programming door control in your function menu.
Alternate
Keystroke
Access Ctl Level
[COMMAND][4][4]
Default:
Selection:
Function
No.
37
Shows the current on or off state of control levels 1
through 14, pertaining to Access Control Only, (L##
Access Level and L## Disarm Level). The user can
Alternate
toggle levels on and off and invalidate access control
Keystroke
levels during an extended period. This change only
[COMMAND][5][8]
affects the user's token or cards; it does not affect
keypad Door Control functions.
Get other manuals https://www.bkmanuals.com
P
-, E, or P
Function Name Alternate
Keystroke
Send Report [COMMAND][4][1]
or
[COMMAND][4][2]
P
-, E, or P
Function Name Alternate
Keystroke
Door Control [COMMAND][4][6]
P
-, E, or P
Function Name Alternate
Keystroke
Access Control (Menu function
Levels only)
EN | 62