S## Defer Test; S## Hourly Report; S## Defer Status - Bosch D9412G Program Entry Manual

D9412G/D7412G | Program Entry Guide | 5.0 RADXSKED
Test Report: This function emulates
9
the Send Report? command center
function. This function generates a Test
Report ONLY from Area 1 but contains
panel-wide status information. The
report is sent to the phone(s)
programmed for Test and Status
Reports in Section 2.3.8 Dialing Attempts.
Expand Test Prt
If
programmed Yes, the Test Report also
includes all off-normal states for events
listed in Diagnostic Reports and Test
Reports (see Section 2.3.8 Dialing
Attempts).
The Test Report can be deferred if any
other report was sent since the last Test
Report. To defer the Test Report,

S## Defer Test

program
The Test Report can be sent every hour
beginning at the time scheduled in
Time
. To send a Test Report every
S## Hourly Rpt
hour, program
Status Report: This function generates
10
a Status Report for each area that is
enabled. The report is sent to the
phone(s) programmed for Test and
Status Reports in Routing.
The Status Report can be deferred if
any other report was sent since the last
Status Report. To defer the Status
Report, program
Bosch Security Systems | 10/03 | 47775E
in Phone is
.
S##
.

S## Defer Status

.
S## Defer Test
Default: No
Selection: Yes or No
Enable sked to defer the Test
Report

S## Hourly Report

Default: No
Selection: Yes or No
Enable sked to send the Test
Report every hour.
S## Defer Status
Default: No
Selection: Yes or No
Enable sked to defer the Status
Report.
EN | 107
Yes Defer the Test
Report.
No Send the Test
Report on
schedule.
Yes Send the Test
Report every hour.
No Send the Test
Report only as
scheduled.
Yes Defer the Status
Report.
No Send the Status
Report on
schedule.