Configure The Local Service Control - Zte ZXHN H2640 Maintenance Management Manual

ZXHN H2640 Maintenance Management Guide(TIM)
Parameter
Egress
DSCP
10. Click Apply button to apply the changes.

4.4.3 Configure the Local Service Control

Abstract
The section describes how to configure local service control.
Steps
Configuring the Service Control-IPv4
1. On the main page of the ZXHN H2640, select Internet > Security > Local Service
Control to the Local Service Control page.
2. Click Service Control-IPv4 to open Service Control-IPv4 page, see
Figure 4-20 Service Control-IPv4 Page
3. Configure the service control-IPv4 parameters.
Table 4-11
4-24
Description
Specify the data traffic direction. The Ingress option and
egress option cannot be the same.


A DSCP is specified for the TOS byte in the IP header of each
packet to indicate the priority. Range: 0–63.
lists the local service control-IPv4 parameters.
If the ingress is LAN, the egress should be a WAN or 3G
connection. The data traffic direction is upstream.
If the ingress is a WAN or 3G connection, the egress
should be the LAN. The data traffic direction is
downstream.
SJ-20200714160642-002 | 2020-07-27(R1.0)
Figure 4-20.