Zte ZXHN H2640 Maintenance Management Manual page 66

ZXHN H2640 Maintenance Management Guide(TIM)
Table 5-4
Table 5-4 Access Control-Mode configuration parameters
Parameter
No Filter
Black List
White List
4. Click Apply button to apply the changes.
Configuring the Access Control-Rule Parameters
5. Click Access Control-Rule Configuration to the configuration page, see
5-6.
Figure 5-6 Access Control-Rule Settings
6. Configure the access control-rule configuration
control-rule configuration parameters.
Table 5-5 Access Control-Rule Configuration parameters
Parameter
Name
SSID
MAC Address
5-6
lists the access control-mode configuration parameters.
Description
No filter is to be applied (the default).
Deny LAN users to access specific address.
Allow LAN users to access specific address.
parameters.Table 5-5
Description
The name of Access Control Item.
SSID name corresponding to the wireless network that the
rule is applied to. The default value is SSID1.
The MAC address of the wireless device.
We suggest to set the MAC addresses in access control list
using a wireline connected device.
Modifying the list using a wireless device may cause
unexpected disconnection of the device used.
SJ-20200714160642-002 | 2020-07-27(R1.0)
Figure
lists the access