Configure The Security; Configure The Firewall Level - Zte ZXHN H2640 Maintenance Management Manual

Parameter
Destination MAC Address
802.1p
VLAN ID
Level 2 Protocol
Source IP
Destination IP
DSCP
Level 3 Protocol
Source Port
Destination Port
TCP ACK
Packets Classification Result
802.1p Re-marking
DSCP Re-marking
Queue Priority
3. Click Apply button to apply the changes.

4.4 Configure the Security

4.4.1 Configure the Firewall Level

Abstract
The section describes how to configure firewall level.
Steps
Configuring the Firewall
1. On the main page of the ZXHN H2640, select Internet > Security > Firewall to the
Firewall page, see
SJ-20200714160642-002 | 2020-07-27(R1.0)
Description
Destination host MAC address.
Specify the 802.1p value to modify the service priority.
Identifies a VLAN. Range: 0–4094. To ensure normal service
operation, the VLAN ID must be the same as that set in upper-
layer configuration.
The level 2 protocol includes: Unconcerned, IPv4, IPv6,
PPPoE.
Source host IP address.
Destination host IP address.
DSCP value.
The Level 3 Protocol includes: Unconcerned, TCP,
ICMP.
Source port number of the matching packets.
Destination port number of the matching packets.
Set radiobox On to enable the function of TCP ACK.
802.1p identifier value.
DSCP identifier.
Range:1-8.
Figure 4-15.
4 Configure the Internet
ARP and
UDP and
4-19