Zte ZXHN H268A User Manual
  1. Manuals
  2. Brands
  3. Zte Manuals
  4. Gateway
  5. ZXHN H268A
  6. User manual

Zte ZXHN H268A User Manual

Home gateway
Hide thumbs Also See for ZXHN H268A:

Advertisement

Table of Contents

See also: User Manual

Advertisement

Table of Contents
loading

Related Manuals for Zte ZXHN H268A

Summary of Contents for Zte ZXHN H268A

  • Page 2 All company, brand and product names are trade or service marks, or registered trade or service marks, of ZTE CORPORATION or of their re- spective owners. This document is provided “as is”, and all express, implied, or statutory...

  • Page 3: Safety Guidance

    Safety Guidance 1.1 Safety Check Before installing the Home Gateway, check all the below listed items: 1. Electric safety Ensure no inflammable, conductive or moist objects and no ageing-cables around the equipment. Place all electrical appliances safely. 2. Equipment position Install the equipment in a ventilated environment avoid of any electric de- �...

  • Page 4: Product Specifications

    Overview 2.1 Features ZXHN H268A is an advanced home gateway. It provides high speed internet, IPTV and voice over IP services through the DSL or GE uplink. It supports the following features: �...

  • Page 5: Hardware Description

    Front panel Figure 3-1 shows the indicators on the front panel of the ZXHN H268A Figure 3-1 The Front Panel Table 3-1 describes the indicators on the front panel of the ZXHN H268A unit. Table 3-1 Descriptions of Indicators LED Indicator...
  • Page 6 (The DSL link is Physical link exists, however carrier wave Slowly Flashing established.) Green has not been detected. ZXHN H268A is not powered on or link has not been established. The link is activated. Broadband (The WAN link is Flashing Green Data is being transmitted.
  • Page 7 ZXHN H268A is not powered on or the USB interface is not connected. Rear panel Figure 3-2 shows the buttons on the side panel of the ZXHN H268A. Figure 3-2 The Side Panel Table 3-2 describes the buttons on the side panel of the ZXHN H268A.

  • Page 8: Hardware Connection

    RJ-45 port. It is used to connect to the network provided by the ISP. WLAN Protected Setup After power on the ZXHN H268A, hold on this button for more Reset than 5 seconds to reset the current settings to the factory default setting, and then the system automatically restarts.
  • Page 9 4. Make sure that the ZXHN H268A with the WiFi function keeps far away from the following devices: Keep at least two meters far away from electrical devices or components that generate RF noise.

  • Page 10: Troubleshooting

    If yes, the computer or application network may be faulty. This is unrelated with DSL. If the ZXHN H268A is ab- normal, check the status of indicators one by one to remove the fault.
  • Page 11 If the DSL suddenly fails to be synchronized (link down) during application, usually the Link indicator on the ZXHN H268A will not be On. It is suggested to check the following steps one by one: i.

Table of Contents