Zte ZXHN H2640 Maintenance Management Manual page 16

ZXHN H2640 Maintenance Management Guide(TIM)
Figure 2-2 The Rear Panel
Interface/
Button
WiFi
WPS
Power
Reset
Tel1–Tel2
USB2
LAN1-LAN3
LAN4/WAN
DSL
Side panel
Figure 2-3
4-2
Function
Wi-Fi dual-interfaces On/Off button.
WPS Push Button, press this button to enable or disable the WPS function.
Power supply port, it is connected to the power adapter.
Reset pinhole, it is used to reset the configuration to factory default settings.
RJ-11 port, it is used to connect to the analog telephone.
USB3.0 host port in right panel.
RJ-45 port, it is used to connect the modem to computer , STB or other network
devices.
RJ-45 port, it is used to connect to the uplink Ethernet access network.
RJ-14 port, it is used to connect to the uplink ADSL, VDSL or VDSL Bonding access
network.
shows the interfaces on the side panel of the ZXHN H2640.
SJ-20200714160642-002 | 2020-07-27(R1.0)