Zte ZXHN H2640 Maintenance Management Manual page 35

Parameter
DNS1–DNS3
VLAN
VLAN ID
In the ZXHN H2640 provisioning, configure only one Internet-WAN connection and
delete other WAN connections.
2. Click Apply button to apply the changes.
Configuring the DSL Modulation Parameters
3. On the main page of the ZXHN H2640, select Internet > WAN > DSL to the DSL
Modulation Parameters page, see
SJ-20200714160642-002 | 2020-07-27(R1.0)
Note
Description
IPv6 address of the DNS server for static connections. You
can set up to three IPv6 addresses for the server. These IPv6
addresses are provided by the ISP.
Specifies whether to carry a VLAN tag in the packets sent over
the WAN connection. By default, On button is not selected. If it
is selected, a VLAN tag is carried in the packets sent over the
WAN connection, and the VLAN ID must be set.
Identifies a VLAN. Range: 0–4094. To ensure normal service
operation, the VLAN ID must be the same as that set in upper-
layer MDU/DSLAM configuration.
Figure 4-8.
4 Configure the Internet
4-9