Zte ZXHN H2640 Maintenance Management Manual page 40

ZXHN H2640 Maintenance Management Guide(TIM)
Table 4-3 3G Configuration Process
Steps Operation
1 Insert 3G device.
2 Check the 3G device status.
3 Create a 3G WAN
connection.
4 Check the 3G connection
status.
Note
What to do when 3G device is not ready?
1. Check whether the dongle is plugged in.
2. If the device is already plugged in, please check whether the USB is contacted well.
3. If the device is still unrecognized, maybe it has been damaged. Please replace the
device.
Steps
1. Insert 3G device.
2. On the main page of the ZXHN H2640, select Internet > WAN > 3G > Mobile
Network to the Mobile Network page. The signal strength can verify the network
card is plugged, see
Figure 4-10 Mobile Network
3. Click Refresh to refresh the information.
4. On the main page of the ZXHN H2640, select Internet > WAN > 3G to the 3G
Connection page.
4-14
Instructions
Null.
The signal strength can verify whether the network card is
plugged.
Click
3G connection.
The IP address getting from carries can verify that the 3G
WAN Connection based on IPv4 was completed successfully.
Figure 4-10.
SJ-20200714160642-002 | 2020-07-27(R1.0)
on the page, and create a new