Configure The Media - Zte ZXHN H2640 Maintenance Management Manual

ZXHN H2640 Maintenance Management Guide(TIM)
2. Set the parameters. For a description of the parameters, refer to
Table 6-5 Parameter Descriptions for the SIP Protocol
Parameter
Local Port
Primary Proxy Server
Primary Outbound Proxy
Server
Primary Proxy Port
Secondary Proxy Server
Secondary Outbound
Proxy Server
Secondary Proxy Port
Primary Registrar Server
Secondary Registrar
Server
Register Expires
Unregister On Reboot
Link Test
Link Test Interval
PRACK
3. Click Apply button to apply the changes.

6.5 Configure the Media

6-6
Description
Local port that the SIP protocol uses, default: 5060.
IP address of the active SIP proxy server that the ISP provides, which
must be the same as that configured on the SIP server.
IP address of the active outbound proxy server that the ISP provides,
which must be the same as that configured on the SIP server.
Port number that the ISP provides for communication between the
active server and VoIP terminals, which must be the same as that
configured on the SIP server, default: 5060.
IP address of the standby SIP proxy server that the ISP provides,
which must be the same as that configured on the SIP server.
IP address of the standby outbound proxy server that the ISP
provides, which must be the same as that configured on the SIP
server.
Port number that the ISP provides for communication between the
standby server and VoIP terminals, which must be the same as that
configured on the SIP server, default: 5060.
IP address of the active SIP registrar server that the ISP provides,
which must be the same as that configured on the registrar server.
IP address of the standby SIP registrar server that the ISP provides,
which must be the same as that configured on the registrar server.
Registered lifecycle, unit: seconds, default: 3600.
Whether to deregister VoIP terminals after the server is restarted. By
default, this function is enabled.
Click On to enable the function. By default, this function is disabled.
Interval of link tests, default: 20 seconds.
PRACK is a mechanism for ensuring the reliable transmission of
temporary messages (101-199) in SIP messages. When this function
is enabled, a temporary response to the 101–199 message can be
made and the message can be transmitted reliably.
SJ-20200714160642-002 | 2020-07-27(R1.0)
Table 6-5.