Zte ZXHN H2640 Maintenance Management Manual page 51

Table 4-11 Parameter Descriptions for the Service Control-IPv4
Parameter
On/Off
Name
Target
Ingress
IP Range
Service Type
4. Click Apply button to apply the changes.
Configuring the Service Control-IPv6
5. Click Service Control-IPv6 to open Service Control-IPv6 page, see
Figure 4-21 Service Control-IPv6 Page
Table 4-12
Table 4-12 Parameter Descriptions for the Service Control-IPv6
Parameter
On/Off
SJ-20200714160642-002 | 2020-07-27(R1.0)
Description
Click On to enable the function.
Click Off to disable the function.
Name of the Service Control item.
The name must be specified.
Specify to discard or permit the data packages.
Specify the data stream inbound direction, and this parameter
must be specified.

If the Ingress is WAN_All, all the WAN connection can access
ZXHN H2640.

If the Ingress is LAN, the LAN side can access ZXHN H2640.

If the Ingress is a WAN or Route_3G connection, the
connection selected can access ZXHN H2640.
The IP address segment that needs to be filtered.
When the IP segment is null, it refers to all the IP addresses.
Specify the service that is permitted or denied to access.
lists the Service Control-IPv6 parameters.
Description
Click On to enable the function.
4 Configure the Internet
Figure 4-21.
4-25