Zte ZXHN H2640 Maintenance Management Manual page 110

ZXHN H2640 Maintenance Management Guide(TIM)
Figure 7-15 Trace Route Diagnosis Page
6. Set the parameters. For the description of the parameters, refer to
Table 7-9 Parameter Descriptions for Trace Route Diagnosis
Parameter
IP Address /Host
Name
Egress
Maximum Hops
Wait Time
Protocol
Notice
 Please don't refresh this page while diagnosing, otherwise the diagnosis result may
be displayed unproperly.
 If a new diagnosis is triggered when the current diagnosis is still running, the device
will only respond to the new diagnosis, and the current diagnostic result will not be
saved.
7-14
Description
Destination IP address or host name for the Trace Route operation.
To detect the connection with an external address, select a WAN connection.
Maximum number of hops that the Trace Route packets require for arriving at
the destination, default: 30.
Time allowed for receiving a response in ms. If no response is received during
this period, an asterisk is displayed. If multiple asterisks are displayed, it
indicates that the corresponding node fails.
Options: UDP and ICMP.
SJ-20200714160642-002 | 2020-07-27(R1.0)
Table 7-9.