Removing Glass Panel For Sliding/Tilting Roof - Skoda OCTAVIA Workshop Manual

60
------------ ------------
Sliding/Tilting Roof
K Aligning panel at rear:
b = 0...1 mm higher than roof
Arrow = direction of travel
- Tighten screws of glass panel fully (4.5 Nm).
- Always align left and right sides of glass panel
symmetrically.
Note:
The height alignment is checked by opening and
closing the sliding/tilting roof.
- Tilt sliding/tilting roof.
K - Attach top trim -2- at rear and clip in place in
the middle and at the front.
- Move bottom trim -1- at rear in slot in direc-
tion of arrow and clip in place in the front.
- Remove glass panel for sliding/tilting roof
⇒ page 60-14.
K - Pull weatherseal -1- off the glass panel.
- Press new weatherseal centred into the glass
panel -2-.
Note:
Coat weatherseal with lubricant (water) to fa-
cilitate installation.
OCTAVIA
Edition 10.99
S00.5118.56.20