Table of Contents
Advertisement
Sliding/tilting roof
What you should be mindful of
Force limiter
To reduce the risk of pinch injuries when closing the
tilt/slide sunroof, the vehicle has a force limiter.
If there is an obstacle, the glass panel closing proc-
ess is stopped and the pane retracts by several cen-
timetres.
If the obstacle is not removed, the force limiter will
be disabled during the third closing attempt. The
sliding/tilting roof will then close with full force.
CAUTION
Risk of injury!
Close the sliding/tilting roof carefully, even though
▶
there is a force limiter.
NOTICE
During winter time, if necessary, remove any ice
▶
and snow around the area of the sliding/tilting roof
before opening.
Always close the sliding/tilting roof before discon-
▶
necting the battery.
Operating conditions
✓ Ignition is switched on.
✓ The outside temperature is higher than -20 °C
(applicable for the opening of the sliding/tilting
roof).
Operation
Tilt step-by-step
A
Tilt in full
B
Reset gradually
C
Reset completely
D
Open step-by-step
A
Open fully
B
Close gradually
C
Close completely
D
Doors, windows and boot lid ›
After moving the switch to position
ing / tilting roof opens into the low-noise position (at
a speed of approximately 80 km / h).
After another shift to position
roof opens completely.
After switching off the ignition, the sliding / tilt-
ing roof can be operated for about 10 minutes as
long as none of the doors are opened.
Easy operation of the sliding / tilting roof
The comfort operation makes it possible to lock the
sliding/tilting roof with the key if necessary.
›
To tilt, hold the button
›
To close, hold the button
On vehicles with a keyless locking system, it is possi-
ble to close the sliding / tilting roof using the sensor
in the door handle of the front door .
›
Hold one finger on the sensor on the outside of the
handle on the front door.
Troubleshooting
Operation of the sliding/tilting sunroof does not
work after disconnecting the vehicle battery
›
Activate the operation of the sliding/tilting
roof
» page
31.
Activation after disconnecting the vehicle
battery
Activation of the operation of the sliding/tilting
roof
›
Turn on the ignition.
›
Pull the switch all the way down and hold it down.
After about 10 secs, the sliding/tilting roof opens
and closes again.
›
Release the switch.
Sliding/tilting roof
31
, the slid-
B
, the sliding / tilting
B
down.
down.
Advertisement
Table of Contents
