Reading Measured Value Block - Skoda OCTAVIA Workshop Manual

01
1J0 962 258 Central locking
Coding 04097
Fault
Coding XXXXX not accepted
Vehicle system test
Select function XX
Vehicle system test
06 End output
Vehicle system test
Select function XX
Vehicle system test
Select function XX
Vehicle system test

08 Reading measured value block

Reading measured value block
Enter display group number XXX
------------ 01-58 ------------
Self-Diagnosis
V 34 → K The control unit identification, the coding and the
WSC 12345 workshop code are shown on the display, e.g.:
If the indicated display content appears, the cod-
ing was successful.
K If the control unit rejects an entered code number,
→
the following message will be displayed:
In this case the control unit was not coded with
the data required for the vehicle.
One must check whether the right control unit
was fitted on the vehicle (part number and char-
acter index), or if the right code was entered.
- Repeat coding
If the control unit cannot be coded (correct con-
trol unit, correct code number) the control unit
is defective.
End function:
- → Press key.
K Read-out on display:
HELP
- Enter function 06.
- Confirm entry with key Q.
Q K Read-out on display:
- Confirm entry with key Q.
K Read-out on display:
HELP
Reading measured value block
The measured value block is subdivided into 9
to 16 display groups (according to generation
of central locking). Each display group is subdi-
vided into max. 4 display fields.
- Connect vehicle system tester V.A.G 1552
and enter address word for central locking
system
K Read-out on display:
HELP
- Enter function 08.
Q K Read-out on display:
- Confirm entry with key Q.
K Read-out on display:
→
page 01-46.
OCTAVIA
Edition 09.03
S00.5118.65.20