44 Doors, windows and boot lid ›
Troubleshooting
The window regulator has stopped working after repeated
opening and closing
The window regulator mechanism could have overheated.
›
Allow the window regulator mechanism to cool down.
The window operation does not work after disconnecting the
12 volt vehicle battery
›
Enable window operation
» page
Activation after disconnecting the 12-volt vehicle
battery
Activate automatic window operation
›
Turn on the ignition.
›
Pull the corresponding button upwards and the window
closes.
›
Release the button.
›
Pull up the respective button and hold for 1 second.
Sliding/tilting roof
What you should be mindful of
To reduce the risk of pinch injuries when closing the tilt/slide
sunroof, the vehicle has a force limiter.
If the operation is activated in the closed direction and the clos-
ing process is hindered by an obstacle, the movement of the
glass pane is stopped and the pane moves back a few centime-
tres.
Sliding/tilting roof
44.
If the obstacle is not removed, the force limit is disabled when
you try to close again by moving and holding a finger in the
closed direction (if the time span between the closing attempts
is less than 5 s). The sliding/tilting roof will then close with full
force.
CAUTION
Risk of injury!
Close the sliding/tilting roof carefully, even though there is a
▶
force limiter.
NOTICE
During winter time, if necessary, remove any ice and snow
▶
around the area of the sliding/tilting roof before opening.
Always close the sliding/tilting roof before disconnecting the
▶
12 volt vehicle battery.
Operating conditions
✓ Ignition is switched on.
✓ The outside temperature is higher than -20 °C (applicable for
the opening of the sliding/tilting roof).