Table of Contents
Advertisement
11 .2 Error Code List
Error code
CA00015
A system error has occurred .
Please reboot .
CA00016
If an error has occurred again after reboot,
please contact your service representative .
CA00017
An error has occurred in booting .
Please reboot the system .
CA00018
If an error has occurred again after rebooting,
please contact your service representative .
An error has occurred in application software .
CA00019
Please contact your service representative .
An error has occurred in firmware.
CA00020
Please contact your service representative .
Please remove the extension probe port after
CA00021
power Off.
AC adapter connector is not inserted properly .
CA00022
Please make sure to fully insert the AC adapter
connector .
System software fails to bootup .
CA07001
Please contact service representative for assis-
tance .
Please shut down the system .
Check Disk
CA07002
Check Hard disk : System drive
Check Hard disk : Data drive
The system could not be restored . Please contact
service representative for assistance .
CA07003
Continued system use is possible but not recom-
mended .
An error has occurred during start-up .
CA07009
Please reboot the system .
If an error has occurred again after rebooting,
please contact your service representative .
System error has occurred .
CA07010
Please reboot the system .
If an error has occurred again after rebooting,
please contact your service representative .
Application is busy .
CA07011
System shut down to force .
Display message
Phenomenon / Solution
Please reboot .
If an error has occurred again after reboot, please contact
your service representative .
Restart the system . If an error reoccurs after restarting the
system, stop using the system and contact your service
representative .
Please stop use of the system, and contact your service
representative .
Please turn off the power of the system. Then remove the
extension probe port .
Insert the AC adapter connector all the way to its base .
Please stop use of the system, and contact your service
representative .
Perform Check Disk .
Once you perform Check Disk, the system is automatically
rebooted . Then the screen goes dark for a few minutes,
which is the normal reboot routine .
If you still have the error after performing Check Disk,
please stop use of the system, and contact your service
representative .
Please stop use of the system, and contact your service
representative .
Please reboot the system .
If an error has occurred again after rebooting, please con-
tact your service representative .
Application may not have been ended successfully .
Please confirm patient data and study data.
292
Advertisement
Table of Contents
