Table of Contents
Advertisement
Labels
WARNING
• Be sure to use the power supply cord that is in-
cluded with the system, and connect the mains
plug (Hospital Grade) to a wall mounted AC socket
outlet . Do not connect the mains plug to a two-pin
socket outlet using conversion adapters, etc . Doing
so may cause an electric shock .
• Where the integrity of the external protective con-
ductor of the facility or its arrangement is doubt-
ful, the system shall be operated with the battery-
powered operation .
• Do not connect a multiple socket-outlet or an exten-
sion cord between the mains plug (with three-core
ground terminal) and a hospital grade mains socket
outlet (three-pin) . Doing so may cause an electric
shock .
• Securely insert the mains plug completely in . In-
complete insertion may cause electric shock or fire
through overheat .
– Do not use damaged plugs or loose socket out-
lets .
– When the mains plug is not in use, pull it out from
the wall mounted AC socket outlet .
• Routinely remove dust or dirt settling on the mains
plug . Dust or dirt accumulation on the mains plug
may result in an insulation failure, causing a fire.
– Disconnect the mains plug and wipe it clean with
a dry cloth .
• To prevent electric shock, do not connect any pe-
ripheral units other than external monitor to an ex-
ternal outlet . Peripheral units should be connected
to the service outlet of the Power Extension Unit2 .
For the connection procedures, contact your ser-
vice representative .
• Do not connect peripheral units other than AC
adapter or printer authorized by Konica Minolta to
the Power Extension Unit2 . Doing so may reduce
the safety of the system .
• When the potential equalization terminal on this
system is connected to the potential equalization
busbar of the facility via a potential equalization
conductor, the potential of connected equipment or
of a connected system is equalized .
Reference Signal Unit
• To prevent the electric shock, be sure to confirm the
following cautions before use .
– There should be no abnormality on the ECG cable .
– ECG Unit should be connected to the specified
ECG cable for the Reference Signal Unit .
• Connect the Reference Signal Unit to the system
prior to attach the ECG electrodes to a patient .
Also, avoid bringing the patient with the ECG elec-
trodes attached into contact with other conductive
parts including grounding . Doing so may cause an
electric shock to the patient when the connector of
the ECG cable touches the live part .
• Do not connect the Reference Signal Unit to any
connector other than USB connector . Doing so may
cause a breakdown .
• Do not let ECG electrodes to touch patient's heart
directly . Doing so may cause a cardiac arrest .
– ECG is Type BF applied part, and is not intended
for direct cardiac application .
• Be sure to use the ECG cable that is included with
the Reference Signal Unit .
• The selection and use of ECG electrodes are the
responsibility of a user .
• Remove any ECG electrodes from your patient be-
fore using equipment such as an electric scalpel,
high-frequency therapy equipment, electric stimulator
or electric defibrillator. Also, make sure to keep any
ultrasound transducer away from the patient . The pa-
tient may get burned or receive an electric shock .
Battery
• Do not immerse the battery in water or seawater,
and do not allow the terminal sections to become
wet . Otherwise, the battery may overheat or the ter-
minal sections may rust .
• Do not remove the external cover from the battery
or damage the cover . Doing so may cause the bat-
tery to leak or overheat .
• If leakage, discoloration, deformation, or other ab-
normalities are found in the battery, stop using the
battery .
• If charging fails to complete after the specified re-
charging time has elapsed, immediately stop further
recharging . Otherwise, the battery may leak, over-
heat, or rupture .
• If liquid leaking from the battery comes into contact
with skin or clothing, flush the affected area imme-
diately with clean water . Otherwise, skin problems
may occur .
• The battery has a limited lifetime . If the operating
time is shorter even when the battery has been fully
charged under the specified conditions, replace the
battery with a new one .
28
WARNING
Advertisement
Table of Contents
