Mitsubishi Electric FR-E800 Series Instruction Manual page 100

 Vector control test operation, PM sensorless vector control test
operation (Pr.800 = "9 or 19")
• A test operation for speed control is available without connecting a motor to the inverter.
The speed calculation changes to track the speed command, and such speed changes can be checked on the operation
panel or by outputting it as analog signals to terminal FM or AM.
NOTE
• Since current is not detected and voltage is not output, monitors related to current and voltage such as output current and
output voltage, etc. and output signals do not function.
• For speed calculation, speed is calculated in consideration of Pr.880 Load inertia ratio.
 I/O signal status during the test operation
• During the test operation, the following signals are disabled.
Input terminal function selection (Pr.178 to Pr.189)
• Brake opening completion (BRI)
• V/F switchover (X18)
• Control mode switchover (MC)
• Torque bias selection 1, Torque bias selection 2 (X42, X43)
Parameters referred to
Pr.178 to Pr.189 (Input terminal function
Pr.190 to Pr.196 (Output terminal function
 Status of the monitoring during the test operation
○: Enabled
×: Disabled (0 is displayed at any time.)
Δ: A cumulative total before the test operation is displayed.
selection)page 328
selection)page 292
Output terminal function selection (Pr.190 to Pr.196)
• Electronic thermal O/L relay pre-alarm (THP)
• Brake opening request (BOF)
• Start time tuning completion (Y39)
4.2 Changing the control method and mode
1
2
3
4
5
6
7
8
9
10
99
4. Control Method