Table of Contents
Advertisement
1.3
Turning the Power On/Off
Turning the power on
Press the power switch (
sounds, and the display changes in the following sequence: FURUNO display → mod-
el display → operation test display (see section 10.10.2). Then the lamp beside the
switch changes as below. The last-used mode is activated in approximately 140 sec-
onds after turning the power on.
Note: The transducer is not automatically retracted at start up. After applying the pow-
er, confirm that the transducer is retracted. If the transducer is retracted, the lamp to
the left of the
key to retract the transducer and then operate the system.
After the power is
turned on, all lamps
are lit.
Turning the power off
1. First retract the transducer with the
es while the transducer is being raised and lights steadily when it is fully raised.
Note: While raising the transducer, the ship speed must be not exceed 15 knots,
to prevent damage to the transducer and hull unit.
2. After the
blank.
If the power switch (
"Raising
make it a practice to retract the transducer before turning off the power.
). The lamp to the left of the power switch lights up. A beep
key is on steadily. If the power goes off by power failure, etc., use the
: Raise/lower keys
key lights steadily, press the power switch (
). is pressed before retracting the transducer, the message
" appears and the transducer is retracted. However, for safety purposes,
1. OPERATIONAL OVERVIEW
After the startup tests are
complete, only the
key lamp is lit.
key. The lamp to the left of the
). until the screen goes
key flash-
1-5
Advertisement
Table of Contents
