Table of Contents
Advertisement
1. OPERATIONAL OVERVIEW
How to set the mid protrusion mark
When [2 Middle Key Setting] (located in the [9 Installation Setting]
→ [4 Hull Unit Setting] menu) is set to [Fixed Position], you can
change the middle point for transducer projection.
1. Use the trackball to place the cursor on the Transducer Posi-
tion Mark.
2. Left-click to show the settings pop-up window.
3. Left-click the
The indication on the [Transducer Position Mark] also moves
as you change the setting.
4. Left-click [Quit] to complete the setup and close the pop-up.
1.5
Screen Brilliance and Panel Dimmer
1.5.1
How to adjust the screen brilliance
If your monitor is one of those listed as compatible on page xvi and the monitor is con-
nected to the control unit via USB, you can adjust the screen brilliance from the control
unit. Turn the BRILL knob clockwise to increase, or counter-clockwise to decrease,
the brilliance.
Note: If your monitor is not listed on page xvi, brilliance cannot be adjusted from the
control unit. Adjust the brilliance at the monitor.
1.5.2
How to adjust the panel dimmer
You can change the brightness of the panel and keys with the following procedure.
1. Press the MENU/ESC key to open the menu.
This step is abbreviated to "Open the menu" in this manual.
Note: You can also open the menu from the right-click pop-up menu. See "Oper-
ation from the right-click pop-up menu" on page 1-16.
1-8
or
button to change the setting.
Advertisement
Table of Contents
