Basic Operation; How To Change The Viewpoint Angle; How To Reset The Viewpoint Position - Furuno FSV-75 Operator's Manual

5.3

Basic Operation

5.3.1

How to change the viewpoint angle

You can observe the 3D objects from various angles by changing the viewpoint. To
change the viewpoint, do as follows:
1. Check that the viewpoint operation mode icon on
tool box is highlighted.
Note 1: If the tool box is hidden, click the [Show/
Hide Tool Box] button on the 3D function panel.
Note 2: If the viewpoint operation mode icon is not
highlighted, click the [Density CALC ON/OFF] but-
ton to turn the density calculation function off.
2. Hold down the left button while moving the track-
ball to change the viewpoint.
5.3.2

How to reset the viewpoint position

There are three methods to reset the viewpoint position.
Reset the viewpoint position using the viewpoint reset button at the top left
of the display
Left-click the viewpoint reset button at the top left of
the display to reset the viewpoint position.
Note: The reset position is based on the setting of
[1 Default View Point] on the [Camera Setting]
menu. See section 5.15.2.
Reset the viewpoint position using the [Default View Point] button on the 3D
function panel
Left-click the [Default View Point] button on the 3D function panel, then select the reset
position.
Viewpoint
reset button
• [From Above]: Viewpoint just above own ship
• [From Port]: Viewpoint from the center of the port side
• [From Starboard]: Viewpoint from the center of the starboard side
• [From Stern]: Viewpoint from the center of the stern side
• [Default Position]: User programmed default position. For how to customize the user
programmed default position, see section 5.15.2.
Left-click the button.
5. 3D MODE
Viewpoint operation mode
icon
Viewpoint reset Viewpoint reset
button button
5-3