Table of Contents
Advertisement
3.
VERTICAL SLANT MODE
3.1
Basic Operating Procedure
Turn the power on.
Note: In the default setting, slant (S) and vertical Slant (VCS) modes are active. To
use other display modes, register the display mode to use from the menu. For how to
register display modes, see section 1.6.2.
Lower the transducer.
• If the mid protrusion key is programmed to [Fixed Position]:
Lowers the transducer to half protrusion.
• If the mid protrusion key is programmed to [Any Position]:
The transducer stops at desired position.
• If the mid protrusion key is programmed to [Fixed Position]:
Lowers the transducer to full protrusion.
• If the mid protrusion key is programmed to [Any Position]:
The transducer stops at desired position.
Set the display range.
Adjust the gain.
Select the vertical slant display (VCS or VCS & FF).
3-1
Advertisement
Table of Contents
