Table of Contents
Advertisement
Error
Error Message
Code
310
Backup Memory Error
311
Backup Data Error
312
Backup Data Corrupt
320
Disk Space Error
321
Gain Adjust Value Fault
322
Low Battery
323
NMEA Port Error
324
IP Address Conflict
325
DLL Error
326
Grade authentication
error 1.
327
Grade authentication
error 2.
Others
900
Motor Step-out
Description (as appears
in error list)
Backup memory write er-
ror.
A backup data faultily set
to default.
A backup data corrupt.
No disk space.
Fault of gain adjust value.
Battery voltage is dropped. The voltage of the battery in-
NMEA port recognition er-
ror.
IP address conflict
DLL recognition error.
Cannot decrypt authentica-
tion file.
MAC address mismatch.
Motor Step-out occurred.
APPENDIX 2 ERROR CODE LIST
Meaning and Remedy
An error occurred while sav-
ing the backup memory. Re-
set the system power.
An error occurred in the
backup data; settings were
reset to default. Reset the
system power.
The backup data is corrupt
and cannot be loaded. Reset
the system power.
Insufficient space to save da-
ta. Remove unnecessary
files from main menu → [5
Record/Recall/Register] → [3
Delete Data] (see
section 8.8).
There is a problem with the
gain values. Reset the sys-
tem power.
side the processor unit is low.
Consult your local dealer for
battery replacement.
There was a problem detect-
ing the NMEA port. Reset the
system power.
More than one connection
has the same IP address.
Have your local dealer check
that the IP addresses are set
as follows:
• Processor Unit: 2
• Transceiver Unit: 1
The DLL (Dynamic Link Li-
brary) file was not recognized
or found. Reset the system
power.
Restart the system. If not rec-
tified, contact your dealer to
request service.
Remedy for this error is not
required because the step-
out is rectified automatically.
If not rectified, error code
"138" occurs.
AP-11
Advertisement
Table of Contents
