Table of Contents
Advertisement
APPENDIX 2 ERROR CODE LIST
Error
Error Message
Code
206
TRX CALIB Verification
Error
207
TRX CALIB Check Error Error of lacking calibration.
210
Processor Unit Input Er-
ror
215
SoC PLL Error
216
RXBMF_FPGA PLL Er-
ror
217
FLT_FPGA PLL Error
218
TRCPU FPGA MISC Er-
ror
220
TRX Board1 COMM Er-
ror
221
TRX Board2 COMM Er-
ror
222
TRX Board3 COMM Er-
ror
223
TRX Board4 COMM Er-
ror
224
TRX Board5 COMM Er-
ror
243
RXBMF_FPGA Timeout No data input from
244
FLT_FPGA Timeout
245
12V voltage Malfunction 12V voltage is over normal
248
PreLoader Error
Processor Unit
301
Processor Unit Fan Er-
ror
304
Transceiver COMM Er-
ror
305
Main Control COMM Er-
ror
306
Sub Control COMM Er-
ror
AP-10
Description (as appears
in error list)
Error of calibration data.
Error occurred in input data
from processor unit.
Error of SoC PLL.
Error of RX_FPGA PLL.
Error of FLT_FPGA PLL.
Error of BMF PCB.
No data input from TRX
Board1.
No data input from TRX
Board2.
No data input from TRX
Board3.
No data input from TRX
Board4.
No data input from TRX
Board5.
PRETRG.
No data input from
PRETRG.
range.
PreLoader program error.
Fan RPM has lowered.
Error occurred in commu-
nication with transceiver.
Error occurred in commu-
nication with main control.
Error occurred in commu-
nication with sub control.
Meaning and Remedy
There is a problem in the data
on the TRX board. Reset the
system power.
There is a communication
problem with the processor
unit. Reset the system pow-
er.
There is a problem with the
transceiver board(s).
• Conduct the board test
(see section 10.10.3) and
check that the results for
all items do not appear in
red.
• Reset the system power.
There is a problem with the
program inside the transceiv-
er. Reset the system power.
Fan RPM is abnormally low.
• Conduct the FAN monitor
test (see section 10.10.5)
and check that the value
for each fan is not red. If
any fan's RPM is shown in
red color, consult your lo-
cal dealer for service.
• Reset the system power.
There is a communication
problem with the transceiver
unit. Reset the system pow-
er.
There is a problem communi-
cating with the control unit.
Reset the system power.
Advertisement
Table of Contents
