Table of Contents
Advertisement
4. FISH FINDER MODE
4.15
How to Select the Fish Finder Model
Do as follows to select the fish finder model connected with this equipment:
1. Open the menu.
2. Select [6 Fish Finder], then left-click.
3. Select [0 Next], then left-click.
4. Select [6 Fish Finder Model], then left-click.
5. Select the desired setting, then left-click.
6. Select [Quit], then left-click.
7. Close the menu.
4.16
[Transducer Setting] Menu
The [Transducer Setting] menu includes the items relevant to the TX and RX settings.
4.16.1
How to open the [Transducer Setting] menu
1. Open the menu.
2. Select [6 Fish Finder], then left-click.
3. Select [0 Next], then left-click.
4. Select [3 Transducer Setting], then left-click.
4.16.2
Menu items on the [Transducer Setting] menu
Note: The settings on the [Transducer Setting] menu must be same as the settings of
the fish finder. The settings on this equipment are not applied to the fish finder.
[1 TX/RX Mode]: Select the TX/RX mode same as the fish finder (Standard or ThruEc-
ho CHIRP).
Note: If [6 Fish Finder Model] (see section 4.15) on the [Fish Finder] menu is set to
[FCV-1200L/1500L], [1 TX/RX Mode] is fixed to [Standard].
[2 Transmission Pulse]: Select the pulse length same as fish finder.
[3 Pulse Length]: Operative when [Manual] is selected at [2 Transmission Pulse]. En-
ter the same value as the fish finder.
4-10
Advertisement
Table of Contents
