Oil Change Reset - If Equipped; Display Menu Items - Jeep Grand Cherokee 2020 Owner's Manual

OK Button

Push the OK button to access/
select the information screens or
submenu screens of a Main Menu
item. Push and hold the OK arrow
button for two seconds to reset displayed/
selected features that can be reset.
Oil Change Reset — If Equipped
Your vehicle may be equipped with an engine oil
change indicator system. The "Oil Change
Required" message will display in the
instrument cluster display for five seconds after
a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil
change indicator system is duty cycle based,
which means the engine oil change interval may
fluctuate, dependent upon your personal
driving style.
Unless reset, this message will continue to
display each time you place the ignition in the
ON/RUN position. To turn off the message
temporarily, push and release the OK button. To
reset the oil change indicator system (after
performing the scheduled maintenance), refer
to the following procedure.
Oil Life Reset
1. Without pushing the brake pedal, place the
ignition in the ON/RUN mode (do not start
the engine).
2. Navigate to "Oil Life" submenu in "Vehicle
Info" in the instrument cluster display.
3. Push and hold the OK button until the gauge
resets to 100%.
Secondary Method For Oil Change Reset
Procedure
1. Without pushing the brake pedal, place the
ignition in the ON/RUN position (do not
start the engine).
2. Fully press the accelerator pedal, slowly,
three times within ten seconds.
3. Without pushing the brake pedal, place the
ignition in the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this
procedure.
GETTING TO KNOW YOUR INSTRUMENT PANEL

Display Menu Items

SRT Instrument Cluster Display Performance
Features
The instrument cluster display can be used to
program the following Performance Features.
SRT Performance Features Controls
To access, press and release either the up or

down arrow button until "SRT" appears in the
instrument cluster display, then press and
release the right arrow button to cycle
through the features. Press the OK button to
select a feature.
97
3