Srt Instrument Cluster Descriptions - Jeep Grand Cherokee 2020 Owner's Manual

94 GETTING TO KNOW YOUR INSTRUMENT PANEL

SRT Instrument Cluster Descriptions

1. Speedometer
Indicates vehicle speed.

2. Tachometer
Indicates the engine speed in revolutions

per minute (RPM x 1000).
3. Temperature Gauge
The temperature gauge shows engine

coolant temperature. After an engine
warm up, any reading within
203°F - 230°F (95°C - 110°C) indicates
that the engine cooling system is
operating satisfactorily.
The pointer will likely indicate a higher

temperature when driving in hot weather,
up mountain grades, or when towing a
trailer. It should not be allowed to exceed
the upper limits of the normal operating
range.
WARNING!
A hot engine cooling system is dangerous.
You or others could be badly burned by steam
or boiling coolant. You may want to call an
authorized dealer for service if your vehicle
overheats.
CAUTION!
Driving with a hot engine cooling system
could damage your vehicle. If the
temperature gauge reads greater than 230°F
(110°C) pull over and stop the vehicle. Idle
the vehicle with the air conditioner turned off
until the pointer drops back into the normal
range. If the pointer remains above 230°F
(110°C), turn the engine off immediately and
call an authorized dealer for service.
4. Fuel Gauge
The pointer shows the level of fuel in the

fuel tank when the Keyless Push Button
Ignition is in the ON/RUN position.
The fuel pump symbol points

to the side of the vehicle where
the fuel door is located.
5. Instrument Cluster Display
The instrument cluster display features a

driver-interactive display. Refer to
"Instrument Cluster Display" in this
chapter for further information.
NOTE:
The hard telltales will illuminate for a bulb check
when the ignition is first cycled.