Parallel Parking Space Assistance Operation/Display - Jeep Grand Cherokee 2020 Owner's Manual

The ParkSense Active Park Assist system will

allow a maximum of six shifts between DRIVE
and REVERSE. If the maneuver cannot be
completed within six shifts, the system will
cancel and the instrument cluster display will
instruct the driver to complete the maneuver
manually.
The ParkSense Active Park Assist system will
only operate and search for a parking space
when the following conditions are present:
Gear position is in DRIVE

Ignition is in the ON/RUN position

ParkSense Active Park Assist switch is acti-

vated
Driver's door is closed

Rear liftgate is closed

Vehicle speed is less than 15 mph (25 km/h)

NOTE:
If the vehicle is driven above approximately
15 mph (25 km/h), the instrument cluster
display will instruct the driver to slow down.
If the vehicle is driven above approximately
18 mph (30 km/h), the system will cancel.
The driver must then reactivate the system by
pushing the ParkSense Active Park Assist
switch.
The outer surface and the underside of the

front and rear fascias/bumpers are clean
and clear of snow, ice, mud, dirt or other
obstruction.
When pushed, the LED on the ParkSense Active
Park Assist switch will blink momentarily, and
then the LED will turn off if any of the above
conditions are not present.
Parallel Parking Space Assistance
Operation/Display
When the ParkSense Active Park Assist system
is enabled the "Active ParkSense Searching -
Press OK to Switch to Perpendicular" message
will appear in the instrument cluster display.
You may switch to perpendicular parking if you
desire. Push the OK button on the left side
steering wheel switch to change your parking
space setting.
STARTING AND OPERATING
NOTE:
When searching for a parking space, use the

turn signal indicator to select which side of
the vehicle you want to perform the parking
maneuver. The ParkSense Active Park Assist
system will automatically search for a parking
space on the passenger's side of the vehicle
if the turn signal is not activated.
The driver needs to make sure that the

selected parking space for the maneuver
remains free and clear of any obstructions
(e.g. pedestrians, bicycles, etc.).
The driver is responsible to ensure that the

selected parking space is suitable for the
maneuver and free/clear of anything that
may be overhanging or protruding into the
parking space (e.g., ladders, tailgates, etc.
from surrounding objects/vehicles).
When seeking for a parking space, the driver

should drive as parallel or perpendicular
(depending on the type of maneuver) to other
vehicles as possible.
241
5