Oil Change Reset - If Equipped; Instrument Cluster Display Menu Items - Jeep WRANGLER 2020 Owner's Manual

130 GETTING TO KNOW YOUR INSTRUMENT PANEL
The Main Menu items consists of the following:
Speedometer

Vehicle Info

Off Road — If Equipped

Driver Assist — If Equipped

Fuel Economy

Trip Info

Stop/Start — If Equipped

Audio

Messages

Screen Setup

Oil Change Reset — If Equipped
Your vehicle may be equipped with an engine oil
change indicator system. The "Oil Change
Required" message will display in the
instrument cluster display for five seconds after
a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil
change indicator system is duty cycle based,
which means the engine oil change interval may
fluctuate, dependent upon your personal
driving style.
Unless reset, this message will continue to
display each time you place the ignition in the
ON/RUN position. To turn off the message
temporarily, push and release the OK button.
To reset the oil change indicator system (after
performing the scheduled maintenance), refer
to the following procedure.
Oil Life Reset
1. Without pushing the brake pedal, place the
ignition in the ON/RUN mode (do not start
the engine).
2. Navigate to "Oil Life" submenu in "Vehicle
Info" in the instrument cluster display.
3. Push and hold the OK button until the gauge
resets to 100%.
Secondary Method For Oil Change Reset
Procedure
1. Without pushing the brake pedal, place the
ignition in the ON/RUN position (do not
start the engine).
2. Fully press the accelerator pedal, slowly,
three times within ten seconds.
3. Without pushing the brake pedal, place the
ignition in the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this
procedure.

Instrument Cluster Display Menu Items

NOTE:
The instrument cluster display menu items
display in the center of the instrument cluster.
Menu items may vary depending on your vehicle
features.
Speedometer
Push and release the up or down arrow button
until the speedometer menu icon is displayed in
the instrument cluster display. Push and
release the OK button to toggle between MPH
and km/h.